ZyXEL Communications wireless n gigbit router zyxel manual Red Hat 9.0 DNS Settings in resolv.conf

Appendix C Setting up Your Computer’s IP Address

•If you have a static IP address, enter static in the BOOTPROTO= field. Type IPADDR= followed by the IP address (in dotted decimal notation) and type NETMASK= followed by the subnet mask. The following example shows an example where the static IP address is 192.168.1.10 and the subnet mask is 255.255.255.0.

Figure 221 Red Hat 9.0: Static IP Address Setting in ifconfig-eth0

DEVICE=eth0

ONBOOT=yes

BOOTPROTO=static

IPADDR=192.168.1.10

NETMASK=255.255.255.0

USERCTL=no

PEERDNS=yes

TYPE=Ethernet

2If you know your DNS server IP address(es), enter the DNS server information in the resolv.conf file in the /etc directory. The following figure shows an example where two DNS server IP addresses are specified.

Figure 222 Red Hat 9.0: DNS Settings in resolv.conf

nameserver 172.23.5.1 nameserver 172.23.5.2

3After you edit and save the configuration files, you must restart the network card. Enter./network restart in the /etc/rc.d/init.d directory. The following figure shows an example.

Figure 223 Red Hat 9.0: Restart Ethernet Card

[root@localhost init.d]# network restart

Shutting down		interface eth0:	[OK]
Shutting down		loopback interface:	[OK]
Setting network parameters:			[OK]
Bringing	up loopback interface:		[OK]
Bringing	up interface eth0:		[OK]

NBG-460N User’s Guide

355