ZyXEL Communications wireless n gigbit router zyxel manual General Screen, 198

Chapter 15 IPSec VPN

15.4 The General Screen

Click Security > VPN to display the Summary screen. This is a read-only menu of your VPN rules (tunnels). Edit a VPN rule by clicking the Edit icon.

Figure 130 Security > VPN > General

The following table describes the fields in this screen.

Table 67 Security > VPN > General

LABEL	DESCRIPTION
#	This is the VPN policy index number.
Active	This field displays whether the VPN policy is active or not.
	This icon is turned on when the rule is enabled.
Local Addr.	This displays the beginning and ending (static) IP addresses or a (static)
	IP address and a subnet mask of computer(s) on your local network
	behind your NBG-460N.
Remote Addr.	This displays the beginning and ending (static) IP addresses or a (static)
	IP address and a subnet mask of computer(s) on the remote network
	behind the remote IPSec router.
	This field displays 0.0.0.0 when the Secure Gateway Address field
	displays 0.0.0.0. In this case only the remote IPSec router can initiate
	the VPN.
Encap.	This field displays Tunnel or Transport mode (Tunnel is the default
	selection).
Algorithm	This field displays the security protocol, encryption algorithm and
	authentication algorithm used for an SA.
Gateway	This is the static WAN IP address or URL of the remote IPSec router. This
	field displays 0.0.0.0 when you configure the Secure Gateway Address
	field in the Rule Setup screen to 0.0.0.0.
Modify	Click the Edit icon to go to the screen where you can edit the VPN rule.
	Click the Remove icon to remove an existing VPN rule.

198

NBG-460N User’s Guide