ADC Campus-REX2 RS USING THE LCD FOR, CONFIGURATION, AND MANAGEMENT

USING THE LCD FOR

CONFIGURATION 7

AND MANAGEMENT

This chapter describes how to use the LCD to set the Campus-REX2 configuration options.

For:	See Page:
Navigating the LCD Menus	98
Setting the HDSL Parameters	99
Configuring the Campus-REX2	103
Restoring the System to Default Values	108
Viewing and Configuring Alarms	109
Configuring Loopbacks	113
Viewing System Information	115
Viewing Status Information	115

The steps in this section use the menu buttons and LCD on the front of the desktop unit or the Campus-Star Campus Management Unit (CMU) to configure the Campus-REX2. With the default settings, the Campus-REX2 is set to operate:

•with the HDSL Operating Mode set to Standard Mode

•with the Standard Mode HDSL Rate set to T1

•as a bridge, with the encapsulation format set to cHDLC and Spanning Tree protocol disabled

•with the Timing Source set to Internal

Depending on the requirements of your network, you may be able to use the default settings for one or more of these options.

Campus-REX2 RS Interface Card User Manual 97