Chapter 3 - Configuring the REX2

•If the Campus-REX2 is connected to a Campus unit with a synchronous interface card, such as a Fractional V.35 card, the timing source depends on the setting of the Primary Timing Source option of the remote unit:

–Set the Timing Source to HDSL if the remote unit is set to Internal or Data Port.

–Set the Timing Source to Internal if the remote unit is set to HDSL.

See the Campus-RS Fractional Interface Card User Manual for information on the Primary Timing Source option.

•If the Campus-REX2 is connected to a Campus unit with a Campus CSU/DS-1 or CSU/DSX-1 interface card, set the Timing Source option to Internal.

Configuring Routing Features

This section provides procedures for configuring routing features such as LAN and Line IP addresses and subnet masks, RIP configuration for dynamic routing, static routing configuration, and DHCP services. See “IP Routing” on page 126 for more information about the routing implementation for the Campus-REX2.

To configure the router, from the REX2 Configuration and Status screen type

4then press ENTER . The Router Configuration screen is displayed.

May 05,

2003

ADC TELECOMMUNICATIONS, CAMPUS RS, Version 4.6D

15:07:12

Local Unit ID:

 

Local I/F: REX2

 

Remote Unit ID: Inactive

Remote I/F: Inactive

 

Circuit

ID:

 

 

 

ROUTER CONFIGURATION

1)IP ADDRESS CONFIGURATION

2)RIP CONFIGURATION

3)STATIC ROUTE CONFIGURATION

4)DYNAMIC ROUTE TABLE

5)STATIC ROUTE TABLE

6)ARP TABLE

7)DHCP SERVICES

(R)eturn (M)ain Menu

ENTER CHOICE>

46

Campus-REX2 RS Interface Card User Manual