Chapter 7 - Using the LCD for Configuration and Management
2To select the transceiver mode:
a Press Next until XCVR Mode is displayed. b Press Enter.
c Press Next until your choice is displayed:
•Master initiates the HDSL link. The other Campus unit must be set to Slave or Auto.
•Slave waits for the other Campus unit to initiate the HDSL link. The other unit must be set to Master or Auto.
•Auto (default) automatically switches between Master and Slave until an HDSL link is established.
The Transceiver Mode option determines the hierarchy of the two Campus units when attempting to establish an HDSL link.
d Press Enter.3To select the HDSL rate:
a Press Next until HDSL RATE is displayed.
bPress Enter.
cPress Next until your setting choice of T1 (default), E1, or 768 is displayed.
dPress Enter.
To continue setting up the system, proceed to “Configuring the
Configuring Extended Mode Parameters
Set the Extended Mode parameters using the following procedure.
1To select the Operating Mode, do one of the following:
•If the mode is set to EXTENDED, go to Step 2.
•If the mode is not set to EXTENDED, press Enter, then press Next until the LCD displays EXTENDED, then press Enter. The Operating Mode changes to OPERATING MODE=Extended.
101 |