ADC Campus-REX2 RS Entering SNMP Parameters

Chapter 3 - Configuring the REX2

2For the REX2 Configuration and Status screen, type 6 then press ENTER . The SNMP Configuration screen is displayed.

Jan 01,	1970	ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1	18:05:29
Local Unit ID:		Local I/F: REX2
Remote Unit ID:		Remote I/F: REX
Circuit	ID:

SNMP CONFIGURATION

1)Unit Name:

2)Location:

3)Contact:

4)SNMP Read Only Community String: public

5)SNMP Read/Write Community String: private

6)	Authentication Trap Status:	Enabled	(Enabled, Disabled)
7)	Trap Receiver 1 IP Address:	0. 0. 0.	0

8)Trap Receiver 1 Community String: trap receiver 1

9) Trap Receiver 2 IP Address: 0. 0. 0. 0

10)Trap Receiver 2 Community String: trap receiver 2

11) Trap Receiver 3 IP Address: 0. 0. 0. 0

12)Trap Receiver 3 Community String: trap receiver 3

(R)eturn (M)ain Menu

ENTER CHOICE>

3Continue with the following sections to enter the required parameters and enable authentication error trap generation.

Entering SNMP Parameters

On this screen, you configure parameters that identify this SNMP-managed device. Also, these SNMP parameters must be set to manage the Campus-REX2 over an SNMP network:

•SNMP Read Only Community String provides the authentication string used for SNMP read-only operations (see Step 4)

•SNMP Read Write Community String provides the authentication string used for SNMP read-write operations (see Step 5)

To set SNMP parameters, enter the following information on the SNMP Configuration screen.

1To enter a Unit Name, type 1 then press ENTER . At the prompt, enter up to 32 characters (use any ASCII character) that identifies for SNMP management this Campus unit.

Maximum length is 32 characters.

Enter Unit Name: REX2_Southall

Campus-REX2 RS Interface Card User Manual 61