Chapter 2 - Configuring HDSL Parameters
Using Standard Mode
Standard mode is the default configuration for the HDSL operating mode. When standard mode is selected, only three HDSL rates (T1, E1, and 768) are available. You can select any of the three options for transceiver mode, however.
1From the HDSL Parameters menu, type 1 then press ENTER if the HDSL Operating Mode is set to Extended. Standard is now displayed as the HDSL Operating Mode.
It is recommended that you leave the Transceiver Mode option set to Auto unless you require that a particular end of the HDSL connection be the Master or Slave.
Also, this value cannot be changed if the HDSL link is up.
2To change the Transceiver Mode, type 2 then press ENTER . The Transceiver Mode changes to the next setting. Repeat until the preferred setting is selected:
•Master initiates the HDSL link. The other Campus unit must be set to Slave or Auto.
•Slave waits for the other Campus unit to initiate the HDSL link. The other unit must be set to Master or Auto.
•Auto (default) automatically switches between Master and Slave until an HDSL link is established.
The Transceiver Mode option determines the hierarchy of the two Campus units when attempting to establish an HDSL link.
3To change the HDSL Rate, type 3 then press ENTER . The HDSL Rate changes to the next setting. Repeat until the HDSL Rate is set to the preferred setting of T1 (default), E1, or 768.
4Type S to save and apply HDSL changes as prompted by:
Enter (S)ave to apply changes !
5To exit the menu, type R (go back one screen) or M (return to the Main Menu).
22 |