Chapter 1 - Installing and Accessing the REX2

The Campus-REX2 can be installed into either a Campus-Star chassis (paired with a Campus-RS or -HRS Line Unit) or into a Campus-RS or -HRS desktop unit. The , installed into either, provides one end of a High-bit-rate Digital Subscriber Line (HDSL) transmission system. When connected to another Campus-RS, Campus-HRS, Campus-T1®, Campus-768®, or Campus-E1® desktop unit or a line unit in another chassis, the Campus system transports digitized voice, data, and video signals over existing copper wire at an HDSL rate specified by the user from a range of rates up to 4.608 Mbps.

When the Campus-REX2 is installed in a Campus-HRS desktop unit or with a Campus-HRS line unit (or older), only T1, E1, and 768 Mbps data rates are supported.

INSTALLING THE CAMPUS-REX2

The following sections describe how to install the Campus-REX2 RS Interface Card into either a:

Campus desktop unit on page 1-3

Campus-Star chassis on page 1-4

Ensure that the Campus-REX2 is installed into a Campus-RS or Campus-HRS desktop unit or into a Campus-Star chassis with a Campus-RS or Campus-HRS line unit only. The Campus-REX2 will not operate if it is installed in an earlier version of these Campus products.

Ensure that you read important information on surge protection for HDSL line installation in the line unit or desktop unit manual before installing the Campus-REX2 interface card.

For information about compatibility between the Campus-REX2 and other Campus products, refer to “Product Compatibility” on page 136.

For information about products that comprise a Campus system, refer to “Composition of a Campus-RS System” on page 120.

2

Campus-REX2 RS Interface Card User Manual