Chapter 1 - Installing and Accessing the REX2

When you have selected or entered configuration changes for some parameters such as bridging or routing, you must save those changes for them to be permanent (saved if power to the Campus-REX2 is cycled). Type R from a configuration screen until you return to the root for that configuration and then save the changes. For example, the REX2 Configuration and Status screen is the root for REX2 configuration.

OPERATING WITH DEFAULT VALUES

Campus-REX2 can be operated using its default settings which include:

•HDSL Operating Mode set to Standard Mode

•Standard Mode HDSL Rate set to T1

•network protocol set to bridge, with the encapsulation format set to cHDLC

•Spanning Tree protocol disabled

•Timing Source set to Internal

Set other configurable options to customize the Campus system to your network requirement as described in the following chapters. The LAN port has a default IP address assigned (192.168.1.1) that you can change to fit your IP networking scheme.

Campus-REX2 RS Interface Card User Manual

17