Chapter 3 - Configuring the REX2

2Manage the Static Route Table, including adding or deleting table entries, by entering any of the following:

P to access the previous screen of the table entries

N to access the next screen of the table entries

F to find a specific table entry; the user is prompted to specify an IP address for the destination device:

Required format is nnn.nnn.nnn.nnn

Enter Destination IP Address: 172.100.200.60

E to display all entries in a table without pages; this provides you the capability to capture this information to a file using a terminal emulation software such as HyperTerminal or ProComm

C to clear all entries from the table

A to add static route table entries (also see “Configuring and Deleting Static IP Routes” on page 51) and the following prompt is displayed:

Required format is nnn.nnn.nnn.nnn

Enter Destination IP Address: 192.128.128.60

Enter Destination IP Subnet Mask: 255.255.255.0

Enter Gateway IP Address: 192.150.10.50

Enter Hop Count: 3

The following message is displayed:

Route added

Hit Any Key to Continue

D to delete a static route table entry (also see “Configuring and Deleting Static IP Routes” on page 51) and the following prompt is displayed:

Required format is nnn.nnn.nnn.nnn

Enter Destination IP Address: 192.128.128.60

3Type R then press ENTER to return to the Router Configuration screen (page 3-46). (Typing M will return you to the Main Menu.)

4If you added or deleted static route entries, go to “Saving the Router Configuration” on page 55 to save your changes.

58

Campus-REX2 RS Interface Card User Manual