Chapter 4 - Managing System Parameters
SETTING THE TIME AND DATE
The time and date parameters provide a common time and date stamp
for system functions such as alarm indications or performance monitoring histories.
1To set the time, type 1 then press ENTER .
2At the prompt, type the time in a
ENTER NEW TIME (FORMAT HH:MM:SS): 16:34:09
The system displays this new time on System Parameters screen.
3To set the date, type 2 then press ENTER .
4At the prompt, type two numbers for the day, two number for the month, and the
ENTER NEW DATE (FORMAT MM/DD/YYYY):04/30/2003
The system displays this new date on System Parameters screen as Apr 30, 2003.
System and date take effect immediately after the values are entered and a save command is not required.
IDENTIFYING THE UNIT AND CIRCUIT
A Campus system supports two different identifiers:
•The Unit ID indicates an individual Campus unit which can be either a desktop unit with an interface card or each interface card and line card combination in a
•The Circuit ID identifies the HDSL circuit between local and remote units and is the same for both.
Do the following to set or change these identifiers.
1From the System Parameters menu, type 3 then press ENTER . At the prompt, enter the Unit ID using a unique identifier up to 32 characters.
Maximum length is 32 characters.
ENTER NEW UNIT ID: Southall Quad 4
67 |