Chapter 7 - Using the LCD for Configuration and Management
Setting Router Configuration
When the network protocol is set to router, you can view the parameters indicated in the sections below. Parameters such as the LINE and LAN IP must be configured through the terminal screens.
Viewing Line and LAN IP Addresses. Complete this section to view the IP addresses. The addresses must be configured through the terminal screens. The LCD navigation to get to this submenu was provided in the section “Accessing LCD REX2 Configuration” on page 104.
1Press Next until you select Router Configuration, then press Enter.
2Press Next until you select Port IP Settings, then press Enter.
The LAN IP address is displayed. If you have not changed the IP address through the terminal screens, then the default IP address of 192.168.1.1 is displayed.
3Press Next to view the LAN subnet mask.
4Press Next to view the LINE IP address.
5Press Next to view the LINE subnet mask.
6Press Escape to return to the Router Configuration menu.
Viewing RIP Configuration. Complete this section to view the configured parameters for RIP. The LCD navigation to get to this submenu was provided in the section “Accessing LCD REX2 Configuration” on page 104.
1Press Next until you select Router Configuration, then press Enter.
2Press Next until you select RIP Configuration, then press Enter.
3Press Next to view the configured parameters for:
•LAN RIP Send
•LAN RIP Rcv (receive)
•LINE RIP Send
•LINE RIP Rcv (receive)
•RIP Host Route
•Poison reverse
•RIP 2 auth
107 |