Chapter 7 - Using the LCD for Configuration and Management
4To change the parameter, press Enter when the parameter is displayed (the current setting of this parameter displays on a separate screen).
5Press Next until the desired (new) setting is displayed, then press Enter.
6Press Escape to return to the Router Configuration menu.
Viewing DHCP Service. Complete this section to view the configured parameter for DHCP service. These parameters must be configured through the terminal screens. The LCD navigation to get to this submenu was provided in the section “Accessing LCD REX2 Configuration” on page 104.
1Press Next until you select Router Configuration, then press Enter.
2Press Next until you select DHCP Service, then press Enter.
None is the default configuration. You can select DHCP Relay through the terminal screen. The configured value is displayed.
3Press Escape to return to the Router Configuration menu.
Saving the REX2 Configuration
If you have changed the
1Press Next until Press ENTER to save REX2 config is displayed.
2 | Press Enter. REX2 CONFIG SAVE IN PROGRESS is displayed. |
3 | After a pause, REX2 CONFIG SAVE COMPLETE is displayed. |
4Press Next to return to the previous screen.
RESTORING THE SYSTEM TO DEFAULT VALUES
You can restore all of the configuration options to their factory default values. To return the system configuration options to their default values:
1Press Escape until CAMPUS RS I/F: REX2 is displayed.
2 Press Enter. S/W VERSN and S/WCKSUM is displayed.
3Press Next six times. Press ENTER to factory reset is displayed.
4Press Enter. The system configuration options return to the default values.
108 |