Chapter 7 - Using the LCD for Configuration and Management
It is recommended that you leave the Transceiver Mode option set to Auto unless you require that a particular end of the HDSL connection be the Master or Slave.
Also, this value cannot be changed if the HDSL link is up.
2To select the transceiver mode:
a Press Next until XCVR Mode is displayed. b Press Enter.
c Press Next until your choice is displayed:
•Master initiates the HDSL link. The other Campus unit must be set to Slave or Auto.
•Slave waits for the other Campus unit to initiate the HDSL link. The other unit must be set to Master or Auto.
•Auto (default) automatically switches between Master and Slave until an HDSL link is established.
The Transceiver Mode option determines the hierarchy of the two Campus units when attempting to establish an HDSL link.
d Press Enter.
3To configure LOOP MODE, do the following:
aPress Next to display LOOP MODE.
bPress Enter.
cPress Next to change the setting from 1 Loop (default) to 2 Loop, then press Enter. The LCD displays LOOP MODE=2 Loops.
4To configure HDSL RATE, do the following: a Press Next to display HDSL RATE.
b Press Enter.102 |