Chapter 3 - Configuring the REX2
6If you are only changing DHCP configuration, go to “Saving the Router Configuration” on page 55 to save your changes.
Saving the Router Configuration
Do not remove power to the Campus unit or disconnect the Line and LAN side network connections when upgrading software or saving configuration.
1Type R and press ENTER until you return to the REX2 Configuration and Status screen (page
Jul 07, 2003 | ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1 08:19:34 | |||
Local Unit ID: |
|
| Local I/F: REX2 | |
Remote Unit ID: |
|
| Remote I/F: REX2 | |
Circuit ID: |
|
|
|
|
|
| REX2 CONFIGURATION | AND STATUS |
|
LAN STATUS: | 100BaseT, Full Duplex, Up |
|
| |
LINE STATUS: | Standard, Auto, T1, Down |
|
| |
MAC ADDRESS: | 00:20:A7:01:02:08 |
|
| |
| 1) | Network Protocol: | Router | (Bridge, Router) |
| 2) | Encapsulation: | cHDLC | (cHDLC, PPP) |
| 3) | Timing Source: | Internal | (Internal, HDSL) |
4)ROUTER CONFIGURATION
5)ROUTER STATISTICS
6)SNMP CONFIGURATION
7)SAVE REX2 CONFIGURATION
WARNING: Configuration change(s) will be lost if not saved before resetting or powering unit down.
(R)eturn
ENTER CHOICE>
2Type 7 to save changes. The following message is displayed to show that the save in progress:
WARNING: Do not power off unit or remove LAN or Line connection.
Saving REX2 configuration; Please wait...
The following message is displayed when the save is completed:
REX2 configuration saved
Hit Any Key to Continue
55 |