Chapter 2 - Configuring HDSL Parameters
It is recommended that you leave the Transceiver Mode option set to Auto unless you require that particular ends of the HDSL connection be the Master and Slave.
Also, this value cannot be changed if the HDSL link is up.
2To change the Transceiver Mode, type 2 then press ENTER . The Transceiver Mode changes to the next setting. Repeat until the preferred setting is selected:
•Master initiates the HDSL link. The other Campus unit must be set to Slave or Auto.
•Slave waits for the other Campus unit to initiate the HDSL link. The other unit must be set to Master or Auto.
•Auto (default) automatically switches between Master and Slave until an HDSL link is established.
The Transceiver Mode option determines the hierarchy of the two Campus units when attempting to establish an HDSL link.
3To change the HDSL Loop Mode from 1 Loop (default) to 2 Loop, type 3 then press ENTER .
4To select an HDSL Rate, type 4 then press ENTER . The Select HDSL Rate screen that is displayed is dependent on whether you selected
1 Loop or 2 Loop for the HDSL Loop Mode. The minimum and maximum rates are:
•for 1 Loop, 128 kbps is the minimum and 2304 Mbps is the maximum selected in 64 kbps increments; the default is 128 kbps
•for 2 Loop, 256 kbps is the minimum and 4608 Mbps is the maximum selected in 128 kbps increments; the default is 256 kbps
24 |