Brother 1250, HL-1030, 1240 service manual Engine PCB Assy / High-Voltage Power Supply PCB Assy

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY

3.15Engine PCB ASSY / High-Voltage Power Supply PCB ASSY

(1)Remove the M4x12 Taptite screw to remove the insulation sheet.

(2)Remove the three M4x12 Taptite screws securing the engine PCB and the high-voltage power supply PCB.

(3)Lift the engine PCB and high-voltage power supply PCB together and disconnect the connector which connects two PCBs together to remove the high-voltage power supply

PCB ASSY.

(4)If necessary, remove the T/R electrode helical spring from the T/R plate.

Screw, bind M4x12

Step (3)

Insulation sheet

Screw, bind M4x10

Screw, bind M4x12

Engine PCB ASSY

T/R electrode helical spring

Step (4)

High-voltage power

supply PCB ASSY

Chute

Fig. 4-55

!CAUTION:

Be sure not to lose the T/R electrode helical spring after removing it.

NOTE:

When re-assembling the T/R electrode helical spring onto the plate, press the spring onto the plate firmly with a flat bladed screwdriver and ensure that it is retained securely.

!CAUTION:

The high-voltage power supply PCB has been upgraded from the middle of September ’99 production to improve the print quality.

In accordance with the change the T/R electrode helical spring has been also changed. As we supply both old and new versions of high-voltage power supply PCB and helical spring, ensure that you replace the same version of them.

The old and new versions are incompatible each other. For details, refer to the parts reference list.

4-31