Preparing the Remote Control
Installing Remote Control Batteries
1 Open the battery com- | 2 Insert batteries. | 3 Replace the compart- |
partment lid. | Insert new two | ment lid. |
Slide the lid with it | batteries in the compart- |
|
pressed down. | ment with the + and - |
|
| poles positioned cor- |
|
| rectly. |
|
BEFORE USE
zYou can check the batteries of the remote control by pressing the [LIGHT] button.
If all buttons on the remote control do not light when the [LIGHT] button is pressed, or but- tons are inoperative when you attempt to operate the projector, replace with new batteries.
zIt is recommended to check the batteries before a presentation.
Remote Control Operating Range
Point the remote control to the infrared |
|
remote receiver on the front or rear of the |
|
projector whenever pressing any button. |
|
z Use the remote control within a distance | 30° |
of approximately 5 m (16.4') from the pro- |
|
jector.
zUse the remote control within an angle of 30° in any direction from directly in front of the infrared remote receiver.
30°
5m (16.4')
5m (16.4')
30°
30° 
The remote control may be inoperative if:
zThere is an obstacle between the remote control and main unit.
zThe infrared remote receiver on the main unit is exposed to direct sunlight or strong light of lighting equipment.
zThe remote control uses infrared light.
zWhen you use two projectors at the same time, you can change the channel settings to pre- vent the two remote controls from interfering with each other (P111).
27
