z You can carry the projector immediately after the use ("Off & Go" function).
z You can turn off the projector by disconnecting the power cord without pressing the [POWER] button (direct power on). (P108)
zThe LED illumination lamp turns on to indicate the lamp is being cooled when the power cord is connected.
Setting Up the Power Management Function
You can use the power management function that turns off the lamp if the projector receives no signal input for a while.
If you enable the power management mode, the projector displays a countdown timer if the projector is receiving no signal input and is not operated for 30 seconds, and approxi- mately 5 minutes later the lamp is turned off and the projector goes into the power man- agement mode.
You can select one of the following power management modes from the menu (P107).
Standby mode
Select this mode if you want to start projection soon.
In the standby mode, the lamp is turned off and cooled down. When the lamp has been cooled down, the [POWER] indicator starts flashing in red and green to indicate it is standby. It will start projection if the input signal is inputted or any button on the top control or remote control is pressed.
Exit mode
Select this mode to turn off the projector automatically.
In the exit mode, the lamp is turned off and cooled down. When the lamp has been cooled down, the [POWER] indicator stops flashing in red and stays on and the power is turned off.
zThe projector becomes inoperative when the lamp is being cooled in a power management mode.
PROJECTING AN IMAGE FROM THE COMPUTER
59
