
Troubleshooting
WARNING Lamp Flash Patterns
The WARNING lamp on the Control Panel flashes in red when there is a trouble in the pro- jector.
z Turn off the projector, wait until the cooling fan stops, and remove the power plug from the AC outlet before dealing with the trouble.
|
| Flash Pattern | Meaning | Countermeasure |
|
|
|
|
|
|
| One flash | Temperature | The temperature inside the projector is too high for some rea- |
|
|
| abnormality | son or the outside air temperature is higher than the specified |
|
|
|
| one. |
|
|
|
| If the problem is inside the projector, check whether the pro- |
|
|
|
| jector is installed and operated normally, turn off the projector |
|
|
|
| to cool its inside, and retry projection. If the same warning |
|
|
|
| occurs again, the projector may be defective. Contact your |
|
|
|
| dealer. |
|
|
|
|
|
|
| Two flashes | Faulty lamp | The lamp has burnt out. Replace the lamp with a new one. If |
|
|
|
| the same warning is experienced again, the lamp drive circuit |
|
|
|
| may be defective. Contact your dealer. |
|
|
|
|
|
|
| Three flashes | Faulty lamp | The lamp cover is open. Turn off the projector and unplug it |
|
|
| cover | from the power outlet, then install the lamp cover and turn on |
|
|
|
| the projector again. |
|
|
|
| If the lamp cover has been installed properly, the lamp cover |
|
|
|
| detection switch may be defective. Contact your dealer. |
|
|
|
|
|
|
| Four flashes | Faulty cooling | The cooling fan or another component may be defective. Con- |
|
|
| fan | tact your dealer. |
|
|
|
|
|
|
| Five flashes | Faulty power | The abnormal voltage is applied to some parts in the power |
| ||||
|
|
| supply | supply or any other failure may be occurred. Turn off the pro- |
TROUBLESHOOTING |
|
|
| jector and unplug it from the power outlet, then plug it to the |
|
|
| outlet and turn on the projector again. Contact your dealer if | |
|
|
|
| |
|
|
|
| the same warning is given. |
|
|
|
|
|
|
| Six flashes | System failure | Some of the functions may be defective. Turn off the projector |
|
|
|
| and retry projection. If the same warning is experienced again, |
|
|
|
| contact your dealer. |
|
|
|
|
|
122