Cisco Systems 3825 Atm umts, Syntax Description Command Modes, Release Modification, Examples

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

atm umts

atm umts

Syntax Description

Command Modes

To select an ATM interface for Universal Mobile Telecommunications System (UMTS) Iub traffic for the atm subinterfaces, use the atm umts Sub-Interface configuration command. This command is used when you want to off load one or more permanent virtual circuit (PVC) traffic packets from a physical ATM shorthaul so as to go over an alternate backhaul. For each alternate backhaul, you need to create a logical shorthaul by creating an atm subinterface. Traffic for the PVCs configured under this logical shorthaul will go through the corresponding alternate backhaul.

atm umts

This command has no arguments or keywords.

Sub-Interface configuration

Command History	Release	Modification
	12.4(4)MR	This command is introduced.
	The following example illustrates the use of atm umts command.
Examples
	Router(config)# interface ATM0/2/0
	Router(config-if)# atm umts-iub
	Router(config-subif)# atm umts
Note You can use this command only when the base atm interface is already enabled as atm umts.
Related Commands	Command		Description
	umts local [ip-address]		This command configures the local IP address for alternate backhaul.
	umts remote [ip-address]		This command configures the remote IP address for alternate
			backhaul.

Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide

A-4 OL-15667-03