Cisco Systems 3825 manual Idle-pattern pattern no idle-pattern

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

idle-pattern

idle-pattern

To specify the data pattern transmitted on the T1/E1 when missing packets are detected on the PWE3 circuit, use the idle-patterncommand in CEM configuration mode.

idle-pattern [pattern] no idle-pattern

Syntax Description	pattern	An 8-bit hexadecimal number that is transmitted as the idle pattern.
Defaults	Default idle-pattern is 0xFF.
Command Modes	CEM circuit configuration
Command History	Release	Modification
	12.4(12)MR2	This command was introduced.
Usage Guidelines	The idle-pattern data is sent to replace the data from missing packets.
	The following example illustrates the use of the idle-patterncommand:
Examples
	Router# config t
	Router(config)# interface cem 0/0/0
	Router(config-if)# no ip address
	Router(config-if)# cem 0
	Router(config-if-cem)# idle-pattern 0x55
	Router(config-if-cem)#xconnect 10.10.10.10 200 encapsulation mpls
	Router(config-if-cem-xconn)# exit
	Router(config-if-cem)# exit
	Router(config-if)# exit
	Router(config)# exit
Related Commands	Command	Description
	cem	Enters circuit emulation configuration mode.
	cem class	Applies the CEM interface parameters defined in the given
		<cem-class-name> to the circuit.
	class cem	Configure’s CEM interface parameters in a class that’s applied to
		CEM interfaces together in the global configuration mode.

	Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03		A-35