Cisco Systems 3825 manual 113

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

show xconnect all

Usage Guidelines The show xconnect all command can be used to display, sort, and filter basic information about all xconnect attachment circuits and PWs.

You can use the show xconnect all command output to help determine the appropriate steps to troubleshoot an xconnect configuration problem. More specific information about a particular type of xconnect can be displayed using the commands listed in the Related Commands table.

Examples	The following example shows show xconnect all command output in the brief (default) display format.
	The sample output shows information about the interfaces and VCs that have been configured to
	transport various Layer 2 packets on the router:
	Router# show xconnect all
	Legend: XC ST=Xconnect State, S1=Segment1 State,					S2=Segment2 State
	UP=Up, DN=Down, AD=Admin Down, IA=Inactive,				NH=No Hardware
	XC ST		Segment 1		S1 Segment 2		S2
	------	+---------------------------------	+	--+	---------------------------------		+--
	UP	ac	Et0/0(Ethernet)	UP	mpls	10.55.55.2:1000	UP
	UP	ac	Et1/0.1:200(Eth VLAN)	UP	mpls	10.55.55.2:5200	UP
	IA pri ac		Et1/0.2:100(Eth VLAN)	UP	ac	Et2/0.2:100(Eth VLAN)	UP
	UP sec ac		Et1/0.2:100(Eth VLAN)	UP	mpls	10.55.55.3:1101	UP

Table A-6describes the significant fields shown in the display.

Table A-6	show xconnect all Field Descriptions
Field		Description
XC ST		• State of the xconnect attachment circuit or PW. Valid states are:
		• UP—The xconnect attachment circuit or PW is up. Both segment 1 and
			segment 2 must be up for the xconnect to be up.
		• DN—The xconnect attachment circuit or PW is down. Either segment 1,
			segment 2, or both segments are down.
		• IA—The xconnect attachment circuit or PW is inactive. This state is valid
			only when PW redundancy is configured.
		• NH—One or both segments of this xconnect no longer has the required
			hardware resources available to the system.
Segment1		Information about the type of xconnect, the interface type, and the IP address the
or		segment is using. Types of xconnects are:
Segment2		•	ac—Attachment circuit.
		• pri ac—Primary attachment circuit.
		• sec ac—Secondary attachment circuit.
		•	mpls—Multiprotocol Label Switching.
		• l2tp—Layer 2 Tunnel Protocol.

	Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03		A-113