Cisco Systems 3825 manual Assigning a QoS Boilerplate to an Interface

Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line

Configuration Sequence

For example, the following command configures the umts-iub local interface with an IP address and port of 20.20.20.21 8888:

Router(config-if)#umts-iub local 20.20.20.21 8888

Step 15 To configure the remote parameters required to establish an IP/UDP backhaul connection, enter the following command including the IP address and port you want to establish the IP/UDP backhaul connection from.

Router(config-if)# umts-iub remote ip-address port

For example, the following command configures the umts-iub remote interface with an IP address and port of 20.20.20.20 8888:

Router(config-if)#umts-iub remote 20.20.20.20 8888

Step 16 Exit the interface configuration mode.

Router(config-if)# exit

Assigning a QoS Boilerplate to an Interface

Use the following instructions to assign a quality of service (QoS) boilerplate to an interface: enabling a multilink interface, enable real-time packet interleaving, specifying an ID number for the multilink interface, configuring a maximum fragment size, enabling multiclass multilink PPP (MCMP), specifying the percent of the interface bandwidth, and assigning the Qos boilerplate. You might also need to enter other configuration commands, depending on the requirements for your system configuration and the protocols you plan to route on the interface.

Note In the following procedure, press the Return key after each step unless otherwise noted. At any time, you can exit the privileged level and return to the user level by entering disable at the Router# prompt.

To assign a QoS boilerplate to a multilink interface, follow these steps, while in the global configuration mode.

Step 1 Enter the interface configuration mode.

Router(config)# interface multilink group-number

Where group-numberis the number of the multilink bundle.

For example, the following command creates a multilink bundle 2:

Router(config)# interface multilink2

Router(config-if)#

Step 2 Assign an IP address and subnet mask to the interface.

Router(config-if)#ip address ip_address subnet_mask

For example, the following command creates a an IP address of 20.20.20.21 and a subnet mask of 255.255.255.0:

Router(config-if)# ip address 20.20.20.21 255.255.255.0

	Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03		4-51