Cisco Systems 3825 manual Show Controller Command, Example Configurations, Configuration Sample #1

Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line

Show Controller Command

Example Configurations

The following examples show two sample configurations:

Configuration Sample #1

network-clock-participate wic 0 network-clock-participate wic 1 network-clock-select 1 E1 0/1/0

controller E1 0/0/0 clock source internal

channel-group 0 timeslots 1-31 speed 64

controller E1 0/1/0 clock source line

channel-group 0 timeslots 1-31 speed 64

Configuration Sample #2

network-clock-participate wic 0 network-clock-participate wic 1 network-clock-select 1 E1 0/0/0

controller E1 0/0/0

clock source line

channel-group 0 timeslots 1-31 speed 64

controller E1 0/1/0 clock source internal

channel-group 0 timeslots 1-31 speed 64

Show Controller Command

Use the show controller command to detect any clocking issues. For example, Slip Secs may indicate a clocking issue (see following example).

mwr1#sh contr e1 0/1/0 E1 0/2 is up.

Applique type is Channelized E1 - balanced No alarms detected.

alarm-trigger is not set

Version info Firmware: 20050421, FPGA: 13, spm_count = 0

Daughter card FPGA version: 0x16, source: Bundled

Framing is NO-CRC4, Line Code is HDB3, Clock Source is Line.

CRC Threshold is 320. Reported from firmware is 320.

VWIC relays are closed

Link noise monitor disabled

Data in current interval (330 seconds elapsed):

0 Line Code Violations, 0 Path Code Violations

243 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

Note The last line of the previous example shows 243 Slip Secs indicating a possible clocking issue.

Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide

OL-15667-03 4-5