Cisco Systems 3825 manual Umts remote, 132, Routerconfig-subif#umts remote 10.10.10.1

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

umts remote

umts remote

To configure local ip address for the atm subinterfaces, use the umts remote Sub-Interface configuration command. This command is used when you want to off load one or more PVC’s traffic from a physical ATM shorthaul to go over alternate backhaul. For each alternate backhaul, you need to create a logical shorthaul by creating an atm subinterface. Traffic for the PVCs configured under this logical shorthaul will go through the corresponding alternate backhaul.

umts remote [ip-address]

Syntax Description	ip-address	The IP address for the entry you wish to establish.
Command Modes	Sub-Interface configuration
Command History	Release	Modification
	12.4(4)MR	This command was introduced.
	The following example illustrates the use umts remote command.
Examples
	Router(config)# interface ATM0/2/0
	Router(config-if)# atm umts-iub
	Router(config-subif)# atm umts
	Router(config-subif)#umts remote 10.10.10.1 5502
Note	The port number will be inherited from the base ATM interfaces’s remote port number.
Related Commands	Command	Description
	atm umts	This command enables the UMTS mode for alternate backhaul.
	umts local [ip-address]	This command configures the remote IP address for alternate
		backhaul.

	Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
A-132	OL-15667-03