Cisco Systems 3825 Sample-rate sample-rate, Command Modes Command History Examples, Cem class

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

sample-rate

sample-rate

To specify in milliseconds the rate hardware samples the data on the attached circuit, use the sample-ratecommand in the circuit emulation (CEM) circuit configuration mode.

sample-rate [sample-rate]

Syntax Description	sample rate	Sample rate translates into the payload-sizesent over the circuit. The default
		is 1 ms.
		•	32-timeslots at 1ms = 256-bytes (32-timeslots * 8-bytes/timeslot/ms)
		•	24-timeslots at 2ms = 384-bytes (24-timeslots * 16-bytes/timeslot/ms)

Command Modes

Command History

Examples

CEM circuit configuration

Release	Modification
12.4(12)MR2	This command was introduced.

The following example illustrates the use of the sample-ratecommand:

Router# config t

Router(config)# interface cem 0/0/0

Router(config-if)# no ip address

Router(config-if)# cem 0

Router(config-if-cem)# sample-rate 2

Router(config-if-cem)#xconnect 10.10.10.10 200 encapsulation mpls

Router(config-if-cem-xconn)# exit

Router(config-if-cem)# exit

Router(config-if)# exit

Router(config)# exit

Related Commands	Command	Description
	cem	Apply CEM class.
	cem class	Applies the CEM interface parameters defined in the given
		<cem-class-name> to the circuit.
	class cem	Configure’s CEM interface parameters in a class that’s applied to
		CEM interfaces together in the global configuration mode.

	Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03		A-69