Cisco Systems 3825 manual Ima-group, Interface atm ima, Show ima interface atm

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

ima-group

ima-group

To define physical links as inverse multiplexing over ATM (IMA) group members, use the ima-groupInterface configuration command. When you first perform the configuration or when you change the group number, the interface is automatically disabled, moved to the new group, and then enabled. To remove the port from the group, use the no form of this command.

	ima-groupgroup-number
Syntax Description	group-number	Specifies an IMA group number from 0 to 3. IMA groups can span multiple
		ports on a port adapter but cannot span port adapters.
Defaults	Physical links are not included in IMA groups.

Command Modes

Command History

Interface configuration

Release	Modification
12.0(5)XK	This command was introduced.
12.4(4)MR	This command was incorporated.

Usage Guidelines	Use the ima-groupinterface command to configure a T1/E1 IMA port adapter interface as part of an
	IMA group.
Examples	The following example shows how to define an IMA group:
	Router(config)# interface ATM0/0/0
	Router(config-if)# no ip address
	Router(config-if)#no atm ilmi-keepalive
	Router(config-if)# ima-group 0
Related Commands	Command	Description
	interface atm	Configures an ATM interface.
	interface atm ima	Configures an ATM IMA group.
	show ima interface atm	Provides information about configured IMA groups or a specific IMA
		group.

	Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
A-36	OL-15667-03