Cisco Systems 3825 manual Gsm-abis congestion onset ms

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

gsm-abis congestion onset

gsm-abis congestion onset

Sets the congestion onset detection level at which the remote router will start suppressing all timeslots that are not defined as critical in an effort to alleviate the congestion.

The onset detection level is defined as x milliseconds of continuous congestion detected. To set the congestion onset, use the gsm-abis congestion onset Interface configuration command.

gsm-abis congestion onset [ms]

Syntax Description	ms	Sets the number of milliseconds for the onset detection level.
Defaults	There are no default settings or behaviors.

Command Modes

Command History

Interface configuration

ReleaseModification

12.4(2)MR This command was introduced.

Examples	The following example shows how to set the onset detection level at 50 ms:
	Router(config)# interface Serial10/1/0:0
	Router(config-if)# no ip address
	Router(config-if)#encapsulation gsm-abis
	Router(config-if)# load-interval 30
	Router(config-if)#gsm-abis local 10.10.10.2 6661
	Router(config-if)#gsm-abis remote 10.10.10.1 5553
	Router(config-if)#gsm-abis congestion enable
	Router(config-if)#gsm-abis congestion onset 100
	Router(config-if)# no keepalive

Related Commands	Command	Description
	gsm-abis congestion abate	Sets the congestion abatement detection level at which the remote
		router will stop suppressing timeslots because congestion has been
		alleviated.
	gsm-abis congestion critical	Defines the critical timeslots that are exempt from suppression
		during congestion onset.
	gsm-abis congestion enable	Sets the congestion detection algorithm to monitor the transmit
		jitter buffer and to send congestion indicator signals to the remote
		when congestion is detected.
	gsm-abis jitter	Sets the amount of transmit jitter delay for the GSM-Abis interface.

	Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03		A-27