Cisco Systems 3825 manual Snmp-server enable traps ipran util, 118

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

snmp-server enable traps ipran util

snmp-server enable traps ipran util

Syntax Description

Defaults

To provide information alarms associated with backhaul utilization via Simple Network Management Protocol (SNMP) notifications (traps) available on your system, use the snmp-server enable traps ipran util command in global configuration mode. To disable ipran alarm-gsm notifications, use the no form of this command.

snmp-server enable traps ipran util

no snmp-server enable traps ipran util

This command has no arguments or keywords.

This command is disabled by default. No notifications are sent.

Command Modes

Command History

Global configuration

Release	Modification
12.4(2)MR1	This command was introduced.
12.4(9)MR	Support for utilization notification has been removed and the command is
	provided only to maintain compatibility.

Examples			The following is an example of the output generated by this command.
			Router(config)# snmp-server enable traps ipran util
Related Commands			Command	Description
			snmp-server enable traps	Provides information alarms associated with GSM-Abis interfaces.
			ipran alarm-gsm
			snmp-server enable traps	Provides information alarms associated with UMTS-Iub interfaces.
			ipran alarm-umts
			snmp-server enable traps	Enables all notifications.
			ipran
			ipran-mib	Specifies the interval used to calculate the utilization.
			backhaul-notify-interval
			ipran-mib	Specifies the acceptable level of traffic.
			threshold-acceptable
			ipran-mib	Specifies the amount of traffic that indicates the backhaul is
			threshold-overloaded	overloaded.
			ipran-mib	Specifies the amount of traffic that indicates the backhaul is carrying
			threshold-warning	traffic sufficient to impact performance, but is not overloaded.
		Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
	A-118			OL-15667-03