A-47
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
ip tos (l2tp)
ip tos (l2tp)
To configure the Type of Service (ToS) byte in the header of Layer 2 tunneled packets, use the ip tos
command in the pseudowire-class configuration mode. To disable a configured ToS value or IP ToS
reflection, use the no form of this command.
ip tos {value value | reflect }
no tos {value value | reflect}
Syntax Description
Defaults The default ToS value is 0.
Command Modes Pseudowire-class configuration
Command History
Usage Guidelines The ip tos command allows you to manually configure the value of the ToS byte used in the headers of
Layer 2 tunneled packets or to have the ToS value reflected from the IP header of the encapsulated
packet.
Note IP ToS byte reflection functions only if traffic in an L2TPv3 session carries IP packets as its payload.
In addition, you can configure both IP ToS reflection and a ToS priority level (from 0 to 255) for a
pseudowire-class. In this case, the ToS value in the tunnel header defaults to the value you specify with
the ip tos value value command. IP packets received on the Layer 2 interface and encapsulated into the
L2TPv3 session have their ToS byte reflected into the outer IP session, overriding the default value
configured with the ip tos value value command.
Examples In the following example, the ToS byte in the headers of tunneled packet s in Layer 2 tunnels created from
the pseudowire-class named “l2tp” is set as 5:
Router# config t
Router(config)# pseudowire-class l2tp
Router(config-pw-class)# ip tos 5
value value Sets the value of the ToS byte for IP packets in a L2TPv3 session. Valid
values range from 0 to 255. The default value is 0.
reflect Sets the value of the ToS byte for IP packets in an L2TPv3 session to be
reflected from the inner IP header.
Release Modification
12.0(23)S This command was introduced.
12.3(2)T This command was integrated into Cisco IOS Release 12.3(2)T.
12.4(12)MR2 This command was integrated into Cisco IOS Release 12.4(12)MR2.