Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line

Configuration Sequence

Step 7 To set the DSCP value used as the interface default DSCP value to tag the backhaul packet, use the following command:

Router(config-if)# umts-iub set dscp value

Where value is a number chosen to represent that packet of traffic.

For example, the following command specifies the number 16 for the packet of traffic for the umts-iub interface:

Router(config-if)#umts-iub set dscp 16

Step 8 Perform Steps 5 through 7 to set another PVC 2/2 with a umts-iub interface DSCP of 8.

Step 9 To overwrite the previous PVC 2/1 with a umts-iub interface DSCP of 16, use the following command:

Router(config-if)# umts-iub set dscp value

Where value is a number chosen to represent that packet of traffic.

For example, the following command overwrites the number 16 for the packet of traffic for the umts-iub interface:

Router(config-if)#umts-iub set dscp 16

Step 10 To configure the local parameters required to establish an IP/UDP backhaul connection, enter the following command including the IP address and port you want to establish the IP/UDP backhaul connection from.

Router(config-if)# umts-iub local ip-address port

For example, the following command configures the umts-iub local interface with an IP address and port of 20.20.20.21 6666:

Router(config-if)#umts-iub local 20.20.20.21 6666

Step 11 To configure the remote parameters required to establish an IP/UDP backhaul connection, enter the following command including the IP address and port you want to establish the IP/UDP backhaul connection from.

Router(config-if)# umts-iub remote ip-address port

For example, the following command configures the umts-iub remote interface with an IP address and port of 20.20.20.20 6666:

Router(config-if)#umts-iub remote 20.20.20.20 6666

Step 12 Perform Steps 1 to 7 for ATM0/0/1 with a UMTS DSCP of 8.

Step 13 To overwrite the previous PVC 2/1 with a umts-iub interface DSCP of 16, use the following command:

Router(config-if)# umts-iub set dscp value

Where value is a number chosen to represent that packet of traffic.

For example, the following command overwrites the number 16 for the packet of traffic for the umts-iub interface:

Router(config-if)#umts-iub set dscp 16

Step 14 To configure the local parameters required to establish an IP/UDP backhaul connection, enter the following command including the IP address and port you want to establish the IP/UDP backhaul connection from.

Router(config-if)# umts-iub local ip-address port

 

Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide

4-50

OL-15667-03

Page 108
Image 108
Cisco Systems 3825 manual Routerconfig-if# umts-iub set dscp value, Routerconfig-if#umts-iub set dscp