Cisco Systems 3825 manual Show mpls l2transport vc, Vcid, Interface, Destination, Detail

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

show mpls l2transport vc

show mpls l2transport vc

To display information about Any Transport over MPLS (AToM) virtual connections (VCs) that have been enabled to route Layer 2 packets on a router, use the show mpls l2transport vc command in the privileged EXEC mode.

show mpls l2transport vc {[vcid vc-id] [vcid vc-id-minvc-id-max]} [interface name

		[local-circuit-id]] [destination ip-address name] [detail]
Syntax Description		vcid	(Optional) Allows you to enter a specific VC ID to display.
		vc-id	(Optional) The VC ID number.
		vc-id-min	(Optional) Allows you to enter a range of VCs to display. The range is from 1 to
		vc-id-max	4294967295. (This argument is primarily used for legacy implementations.)
		interface	(Optional) The interface or subinterface of the router that has been enabled to
			transport Layer 2 packets. This keyword lets you display information about the VCs
			that have been assigned VC IDs on that interface or subinterface.
		name	(Optional) The name of the interface or subinterface.
		local-circuit-id	(Optional) The number assigned to the local circuit. This argument value is
			supported only by the following transport types:
			• For ATM adaptation layer 5 (AAL5) and cell relay, enter the virtual path
			identifier (VPI)/virtual channel identifier (VCI) of the PVC.
			• For Ethernet VLANs, enter the VLAN number.
		destination	(Optional) Information about the VCs that have been assigned VC IDs for the
			remote router you specify.
		ip-address	(Optional) The IP address of the remote router.
		name	(Optional) The name assigned to the remote router.
		detail	(Optional) Detailed information about the VCs that have been assigned VC IDs.
Command Modes		Privileged EXEC
Command History		Release	Modification
		12.1(8a)E	This command was introduced.
		12.0(21)ST	This command was integrated into Cisco IOS Release 12.0(21)ST.
		12.0(22)S	This command was implemented on the Cisco 10720 router.
		12.0(23)S	The interface and destination keywords were added.
		12.2(14)S	This command was integrated into Cisco IOS Release 12.2(14)S.
		12.2(14)SX	This command was implemented on the Supervisor Engine 720.
		12.2(14)SZ	This command was integrated into Cisco IOS Release 12.2(14)SZ.
		12.2(15)T	This command was integrated into Cisco IOS Release 12.2(15)T.
		12.2(18)S	This command was implemented on Cisco 7304 routers.
		12.0(25)S	This command was updated with new output and fields to display information
			about tunnel selection and ATM cell relay port mode.
			Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
	OL-15667-03			A-95