Cisco Systems 3825 manual Configuring Umts Links, Routerconfig-if# exit

Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line

Configuration Sequence

Step 10 Return to Step 1 to configure the next port of the Cisco 2-port T1/E1-RAN interface card and any other ports on additional Cisco 2-port T1/E1-RAN interface cards.

Step 11 Exit the interface configuration mode.

Router(config-if)# exit

Configuring UMTS Links

Note The following is an example of configuring an E1 on the Cisco 2-port T1/E1-RAN interface card in a Cisco 3825 router.

Use the following instructions to perform a basic Universal Mobile Telecommunications System (UMTS)-Iub configurational on the Cisco 2-port T1/E1-RAN interface card located in the Cisco 3825 router, enter the following Cisco IOS commands at the router prompt (see the “Understanding the Cisco 3825 Router Interface Numbering” section on page 3-1for information about slot and port numbering on the Cisco 3825 router). You might also need to enter other configuration commands, depending on the requirements for your system configuration and the protocols you plan to route on the interface.

Note In the following procedure, press the Return key after each step unless otherwise noted. At any time, you can exit the privileged level and return to the user level by entering disable at the Router# prompt.

To configure the UMTS-Iub attributes, follow these steps beginning in the global configuration mode:

Step 1 Set the card type for the Cisco 2-port T1/E1-RAN interface card.

Note This configuration assumes that the Cisco 2-port T1/E1-RAN interface card is installed in all three Cisco 2-port T1/E1-RAN interface card slots (physical slots HWIC0, HWIC1, HWIC2, and HWIC3) of the Cisco 3825 router.

•e1—Card type E1.

•t1—Cart type T1.

•slot—Slot number of the interface.

•subslot—Specifies the Cisco 2-port T1/E1-RAN interface card (serial slot) port number.

Router(config)# card type {e1 t1} slot subslot

For example, there is no Cisco 2-port T1/E1-RAN interface card located in the Cisco 3825 router serial slot 0 (physical slot HWIC0). So, the interface card is located in physical slot HWIC1. As a result, the following command configures the Cisco 2-port T1/E1-RAN interface card located in the Cisco 3825 router serial slot 0 (physical slot HWIC1), the first port of the Cisco 2-port T1/E1-RAN interface card as a E1:

Router(config)# card type e1 0 1

	Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
4-24	OL-15667-03