Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

cdp enable

cdp enable

To enable Cisco Discovery Protocol (CDP) on an interface, use the cdp enable command in interface configuration mode. To disable CDP on an interface, use the no form of this command.

cdp enable

Syntax Description This command has no arguments or keywords.

Command Modes

Command History

Interface configuration

Release

Modification

10.3

This command was introduced.

 

 

12.4(4)MR

This command was incorporated.

 

 

Usage Guidelines

Note

Examples

CDP is enabled by default at the global level and on each supported interface in order to send or receive CDP information. However, some interfaces, such as ATM interfaces, do not support CDP.

The cdp enable, cdp timer, and cdp run commands affect the operation of the IP on demand routing feature (that is, the router odr Global configuration command). For more information on the router odr command, see the “On-Demand Routing Commands” chapter in the Cisco IOS Command Reference, Volume 2 of 3: Routing Protocols document.

In the following example, CDP is disabled on the Ethernet 0 interface only.

Router# show cdp

Global CDP information

Sending CDP packets every 60 seconds

Sending a holdtime value of 180 seconds

Sending CDPv2 advertisements is enabled

Router# config terminal

Router(config)# interface ethernet 0

Router(config-if)# no cdp enable

Related Commands

Command

Description

 

cdp run

Re-enables CDP on a Cisco device.

 

 

 

 

cdp timer

Specifies how often the Cisco IOS software sends CDP updates.

 

 

 

 

router odr

Enables on-demand routing on a hub router

 

 

 

 

Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide

A-10

OL-15667-03

Page 142
Image 142
Cisco Systems 3825 manual Cdp enable, Command Modes Command History, Usage Guidelines Examples