A-25
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
gsm-abis congestion enable
gsm-abis congestion enable
The congestion detection algorithm monitors the transmit jitter buffer and sends congestion indicator
signals to the remote when congestion is detected. The remote will suppress all timeslots that are not
defined as critical in an effort to alleviate the congestio n. The goal of the congestion detection algorithm
is to save the critical timeslots from loss of data. To enable the congestion detection algorithm, use the
gsm-abis congestion enable Interface configuration command.
gsm-abis congestion enable
Syntax Description This command has no arguments or keywords.
Defaults There are no default settings or behaviors.
Command Modes Interface configuration
Command History
Examples The following example shows how to enable th e gsm-abis congestion:
Router(config)# interface Serial10/1/0:0
Router(config-if)# no ip address
Router(config-if)# encapsulation gsm-abis
Router(config-if)# load-interval 30
Router(config-if)# gsm-abis local 10.10.10.2 6661
Router(config-if)# gsm-abis remote 10.10.10.1 5553
Router(config-if)# gsm-abis congestion enable
Router(config-if)# no keepalive
Related Commands
Release Modification
12.4(2)MR This command was introduced.
Command Description
gsm-abis congestion abate Sets the congestion abatement detection level at which the remote
router will stop suppressing timeslots because congestion has been
alleviated.
gsm-abis congestion critical Defines the critical timeslots that are exempt from suppression
during congestion onset.
gsm-abis congestion onset Sets the congestion onset detection level at which the remote router
will start suppressing all timeslots that are not defined as critical in
an effort to alleviate the congestion.
gsm-abis jitter Sets the amount of transmit jitter delay for the GSM-Abis interface.