Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

umts-iub backhaul-oam

umts-iub backhaul-oam

To configure the local parameters required to provide OAM cells received on the UMTS ATM interface to be sent across the backhaul, use the umts-iubbackhaul-oamInterface configuration command. To not transport the OAM cells across the backhaul, use the no form of this command.

Note When using the no form of the command, the end devices may only use OAM loopback cells. I.610 OAM messages are not supported by the Cisco 3825 router; therefore, if you are using this mode, OAM cells should be backhauled.

Additionally, the pvc-oam manage Interface configuration for ATM-VC commands at the PVC configuration level should be enabled for UMTS PVCs on the Cisco 3825 router. These PVCs will respond to OAM cells if the no version of the umts-iubbackhaul-oamcommand is used.

umts-iub backhaul-oam

Syntax Description This command has no arguments or keywords.

Defaults

There are no default settings or behaviors.

Command Modes

Command History

Interface configuration

ReleaseModification

12.4(2)MR

This command was introduced.

 

 

Examples

The following example shows how to configure the local parameters:

Router(config)# interface ATM0/2/0

Router(config-if) atm umts-iub

Router(config-if)umts-iub local 10.10.10.2 5504

Router(config-if)umts-iub backhaul-oam

 

Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide

A-122

OL-15667-03

Page 254
Image 254
Cisco Systems 3825 manual Umts-iub backhaul-oam, 122, Routerconfig-if atm umts-iub