Cisco Systems manual Configuring for Snmp Support, Standalone Cisco 3825 Router

Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line

Configuration Sequence

Step 17 Continue to configure HSRP to track Multilink1 and Loopback103 if needed.

Step 18 Specify a priority of 100.

Router(config-if)#standby group priority 100

Note If you are using the Cisco 3825 in a redundant configuration, you must also set the keepalives under the GE interface to 1.

Router(config-if)# keepalive 1

Standalone Cisco 3825 Router

The Cisco 3825 router has relays that work with a special y-cable for redundancy and that are controlled by HSRP. You can, however, use the Cisco 3825 as a standalone device. If you choose not to use the Cisco 3825 in a redundant configuration, you should not configure HSRP and you must manually control the relays of the Cisco 2-port T1/E1-RAN card.

To manually set the relays to open or closed, follow these steps, while in the global configuration mode:

Step 1 To go to the redundancy mode, enter redundancy mode:

Router(config)# redundancy

Step 2 In the redundancy mode, enter the y-cable mode:

Router(config-r)# mode y-cable

Step 3 Specify that the router is to be used as a standalone device. This command closes the relays.

Router(config-r-y)# standalone

Step 4 Exit y-cable configuration mode.

Router(config-r-y)# exit

To verify the status of the relays on an Cisco 3825 router, use the show controllers command.

Configuring for SNMP Support

Use the following instructions to configure for Simple Network Management Protocol (SNMP) support: setting up the community access, establishing a message queue for each trap host, enabling the router to send SNMP traps, enabling SNMP traps for alarms, and enabling SNMP traps for a specific environment. You might also need to enter other configuration commands, depending on the requirements for your system configuration and the protocols you plan to route on the interface.

Note In the following procedure, press the Return key after each step unless otherwise noted. At any time, you can exit the privileged level and return to the user level by entering disable at the Router# prompt.

	Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03		4-33