Delta Electronics DOP-A/AE/AS manual Rxd Txd Gnd

Delta DOP Series HMI Connection ManualDOP-A/AE/AS Series

if the read/write address format is set to Rn, only Bit 0 ~ 23 are valid for Rn registers.

(Notice: As the Jetter controller is a 24-bit format controller, the valid setting range is 24 Bits. If exceeds this range, HMI will stop read/write operation and show “…..Value is Incorrect” on the screen. So, please do not set any bit on Bit24 ~ Bit31 (Bit24 ~ Bit31 cannot be written).

yWhen using devices that the data length is in m Words,

if the read/write address format is set to WRn, the Bit 0 ~ 15 of WRn register is the lowest word of a read/write value and the Bit 0 ~ 15 of WRn+m-1 register is the highest word of a read/write value. if the read/write address format is set to Rn, the Bit 0 ~ 23 of Rn register is the lowest word of a read/write value and the Bit 0 ~ 23 of Rn+1 register is the highest word of a read/write value.

Each register is regards as a “Double Word”. The value of Bit24 ~ Bit31 is 0.

Contacts

		Contact type	Format					Read/Write Range
						Word No.			Bit No.
	Input Relay		Inbb		n: 1 ~ 32		bb:	01 ~ 08
	Output Relay		Onbb		n: 1 ~ 32		bb:	01 ~ 08
	Flag Relay		Fn		N/A		n:	0 ~ 32767
C. Connections (Connector Pinouts)
RS-232
		DOP Series				Controller			Controller
									9 pin D-SUB male
	9 pin D-SUB male (RS-232)			9 pin D-SUB male (RS-232)
									(RS-232)
									Pin1
		RXD (2)				(2) TXD
		TXD (3)				(3) RXD
		GND (5)				(7) GND			Top View

¾The pin definition of the cable of Jetter controller is different than the general RS-232 cable. Please pay close attention.

Revision January, 2008, Doc. Name: 2007PDD23000007 1-41