Eicon Networks DIVA T/A ISDN manual Windows 95 Original Release and SP1, DUN 1.2 or Later Required

Windows 95/98/NT Installation and Setup

Windows 95 (Original Release and SP1)

This install procedure is for the original release and Service Pack 1 (SP1) version of Windows 95. If you are using Windows 95 Service Release 2 (OSR2), go to “Windows 95 (OSR2)” on page 12.

To verify the version installed on your machine, click ‘Start’, ‘Settings’, ‘Control Panel’, ‘System’, then click the ‘General’ tab. If you have the original or SP1 version of Windows 95 installed, you will see ‘4.00.950’ or ‘4.00.950 A’, as shown.

DUN 1.2 or Later Required

If you are using Dial-Up Networking (DUN), make sure you are using version 1.2 or later. If you are running a previous version, you must upgrade to DUN 1.2 or later before installing the DIVA T/A. For your convenience, DUN 1.3 is included on the DIVA T/A CD-ROM; run SETUP.EXE from the CD-ROM and click ‘Bonus Software’.

Setup Instructions

Follow these steps to set up the DIVA T/A under Windows 95 (Original Release and SP1).

1Power on your PC with all cables connected (see page 7 for instructions).

2Windows 95 detects the DIVA T/A and the ‘New Hardware Found’ window appears.

3Insert the DIV AT/A CD into your computer's CD drive.

4In the ‘New Hardware Found’ window, select ‘Driver from disk provided by hardware manufacturer’ and click ‘OK’. The ‘Install From Disk’ window appears.

DIVA T/A ISDN Modem User’s Guide ◆ Page 10