Windows 95/98/NT Installation and Setup
To properly set up the DIVA T/A with a Windows 95/98/NT system, you must connect the cables, configure the operating system, and install the DIVA Terminal Adapters Software. Once the Terminal Adapters software is installed, you will use the Configuration Wizard to set your ISDN parameters.
Step 1: Connect the Cables to your DIVAT/A
Following the steps outlined on page 7.
Step 2: Configure your Operating System
The configuration procedure you must follow depends on the flavour of Windows you are using. After you have finished connecting the cables and gathering the required information, go to the page that corresponds to your platform.
• Windows 95 | (Original Release and SP1) | ....................................................10 | |
• | Windows 95 | (OSR2) | 12 |
• | Windows 98 | ......................................................................................................... | 14 |
• | Windows NT 4.0 | 16 | |
• | Windows NT 3.51 | 19 | |
Note: If you are using Windows 3.x, see page 31.
Step 3: Install the DIVA Software
The Setup Wizard installs all necessary files on your system. These include the DIVA T/A
Following the steps outlined on page 20.
DIVA T/A ISDN Modem User’s Guide ◆ Page 9
