Emerson 40-200KVA user manual Bolting Cabinets Together, Bolting a Liebert Nxups to a Liebert BDC

Liebert® BDC™

7.5Bolting Cabinets Together

NOTE

UPS wiring must be completed before the cabinets are bolted together.

1.Line up cabinets so that mounting holes are aligned.

Figure 23 Bolting a Liebert® NX™UPS to a Liebert BDC™

Air

Exhaust

Input

Wires

TOP VIEW

23.5"

(597mm)

Output
Cable Plate		Including Hinge and
(See Note 4)	39.5" (1003mm)
	38.6" (980mm)	Bezel Projection
Control
Wires
		78.7?
		(2000mm)
Cable
Pass-Through
Area

RIGHT SIDE VIEW

Right Side Output

REAR VIEW

Cable Entry Area

9.5 x 6.5 (241mm x 165mm)

23.5"

(597mm)

1.2"

FRONT VIEW

(30mm)

Input Landing

17"

36.4"

34.0"

10 x 5.7 (254mm x 145mm)

(432mm)

3.1"

(925mm)

(864mm)

(80mm)

8.3" (211mm)

27.7"

19.9

(702mm)

(504mm)

Inlet Area

6.0"

For Cooling

(152mm)

Output Cable Plate

11.5"

(See Note 4)

Pedestal Location

(292mm)

Ø0.9" (22mm) Typical

FRONT

BOTTOM VIEW

Base Footprint Shaded Area

Notes

Indicates Floor Cutout Dimensions

1. All dimensions are in inches (mm).

For Colling Air And Cable Entry/exit

2. 24" (610mm) minimum clearance above unit required for air exhaust.

3. Keep cabinets within 15 degrees of vertical.

Full Load

4. Output Cable Plates

Unit

Weight

Heat Output

Panelboard Option: Top output plates have 84 knockouts for

kVA

lb (kg)

BTU/HR (kw)

1/2" conduit per plate. Bottom output plates have 84 plugs

75

1350 (6128)

8150 (239)

for 1/2" conduit per plate.

Output Circuit Breaker Option: Top and bottom output plates

125

1650 (748)

11,500 (3.37)

are removable blank plates. Remove, punch to suit conduit size and reinstall.

5.Control wiring and power wiring must be run in separate conduits.

6.All wiring is to be in accordance with national and local electrical codes.

7.Depth dimensions include front and rear doors.

8. Width dimensions without side panels. Add 2.2 (56mm) when adding	FPC13600
both side panels.	Rev. 4

9.Clearance of 36" (914mm) minimum is recommended at front and rear for service access.

2.Using supplied hardware, bolt the cabinets together. The bolts may be inserted from either the UPS side or from the Liebert BDC side, whichever is more convenient.

49