Change during operation: N = impossible, Y* = possible (enabled by using
FUNC DATA
), Y= possible (enabled by using 
)
F23 | Starting frequency |
|
|
| Factory | Change during |
|
|
| setting | Operation | ||
| ||||||
|
|
|
|
|
|
|
|
|
|
| F23 | 1Hz | N |
|
|
|
|
|
|
|
F25 | Stop frequency | F25 | 1Hz | N | ||
|
|
| ||||
| These functions set a starting or stop frequency in a range Starting frequency stop frequency | |||||
| from 1 to 6Hz in 1Hz step. |
|
| |||
1 | 1Hz | Starting |
to |
| frequency setting |
| Stop | |
6 | 6Hz | frequency setting |
Output frequency in forward/ | t | |
| reverse operation | Starting frequency < stop frequency |
Stop frequency setting
Starting frequency setting
Starting frequency setting
Stop frequency setting
FWD
REV
Data cannot be
F24
changed.
0.2Hz
Stop
frequency setting Starting frequency setting
t
If the set frequency is lower than the stop frequency, the drive output is 0Hz.
Factory | Change during |
setting | operation |
0.0 | - |
F26 Motor sound (carrier freq.)
Factory | Change during |
setting | operation |
2kHz | Y |
This function changes the motor tone quality by changing the carrier frequency.
0
to 
Choose among 16 types according to the usage conditions.
1 
5
Data code 0 : 0.75kHz (Low carrier)
1 : 1kHz
2 : 2kHz
15 : 10kHz (High carrier, low noise)
Note: When the drive is operating at 9kHz or higher carrier frequency, the carrier frequency for may be reduced to 8kHz automatically to protect the drive.
