Honeywell 2700 Push Button Functionality, Scale Zero, Image Capture, LEDs Sound Indication

LEDs (Continued)	Sound	Indication
Green, Red, Yellow Flash	Auxiliary Scanner Beep	Auxiliary Scanner Configuration
Green, Red, Yellow Flash	With or without Beep	Scale Calibration
Red Flash	Razz	Error Event - Minor (See Troubleshooting a
		Stratos Bioptic Scanner, beginning on page
		15-1)
Red Flash, then Continuous	Razz	Error Event - Major (See Troubleshooting a
		Stratos Bioptic Scanner, beginning on page
		15-1)
Green Flash	Cuckoo Beep	Configuration Code - Temporary
Green Flash	Ascending 3 Tone	Configuration Code - Permanent

Push Button Functionality

Push Buttons

There is a ring of 4 push buttons on the front of the device. The following is a brief description of the default settings for the push buttons. For complete functionality and programming options, refer to Button Controls on page 4-4.

Note: Pressing the Sound button wakes the scanner from sleep mode.

Scale Zero

This button is normally lit when the scale is at zero. The backlight goes off when the scale is not at zero. Press this button to reset the scale to zero.

Image Capture

Press this button once to scan a bar code using a customer-facing scanner (if installed). Push it a second time to disable the customer-facing scanner. See Image Capture Button on page 4-7for further information.

Sound

Press repeatedly to scroll through the beeper volumes. This button is also used to clear error conditions (LED lights, beeps, and LCD notifications). Hold this button down for 5 seconds to put the scanner to sleep.

1 - 4