
Scan the following bar code to set the communication check character type. Default = None.
* None
LRC Starts on 1st Character
LRC Starts on 2nd Character
CRC
Intercharacter, Interfunction, and Intermessage Delays
Some terminals drop information (characters) if data comes through too quickly. Intercharacter, interfunction, and intermessage delays slow the transmission of data, increasing data integrity.
Intercharacter Delay
An intercharacter delay of up to 65535 milliseconds (in 1ms increments) may be placed between the transmission of each character of scanned data. Scan the Intercharacter Delay bar code below, then scan the number of 1ms delays, and the Save bar code using the Programming Chart inside the back cover of this manual.
Prefix
Scanned Data
Suffix
1 2
3
4
5
Intercharacter Delay
Intercharacter Delay
To remove this delay, scan the Intercharacter Delay bar code, then set the number of delays to 0. Scan the Save bar code using the Programming Chart inside the back cover of this manual.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 65535 milliseconds (in 1ms increments) may be placed after the transmission of a particu- lar character of scanned data. Scan the Delay Length bar code below, then scan the number of 1ms delays, and the Save bar code using the Programming Chart inside the back cover of this manual.
7 - 5