3

Programming the Bioptic Scanner Interface

Introduction

This chapter describes how to program the Stratos bioptic scanner for the desired interface. To program the scale interface, refer to Programming the Scale Interface, beginning on page 6-1.

Printing Single Bar Codes

If you wish to print single-page bar codes for any programming selection, hover your cursor over the bar code, and left click. A document with that bar code on a single page is displayed. Click the Print button to print that page.

The bar code document contains all the programming bar codes from this manual. You can scroll through the pdf to locate any other codes in which you are interested.

Menu Bar Code Security Settings

Honeywell scanners are programmed by scanning menu bar codes or by sending serial commands to the scanner. If you want to restrict the ability to scan menu codes, you can use the Menu Bar Code Security settings. Contact the nearest technical sup- port office (see Technical Assistance on page 16-1)for further information.

Setting Custom Defaults

You have the ability to create a set of menu commands as your own, custom defaults. To do so, scan the Set Custom Defaults bar code below before scanning the menu commands for your custom defaults. If a menu command requires scanning numeric codes from the back cover, then a Save code, that entire sequence will be saved to your custom defaults. When you have

entered all the commands you want to save for your custom defaults, scan the Save Custom Defaults bar code.

Set Custom Defaults

Save Custom Defaults

You may have a series of custom settings and want to correct a single setting. To do so, just scan the new setting to overwrite the old one. For example, if you had previously saved the setting for Beeper Volume at Low to your custom defaults, and decide you want the beeper volume set to High, just scan the Set Custom Defaults bar code, then scan the Beeper Volume High menu code, and then Save Custom Defaults. The rest of the custom defaults will remain, but the beeper volume setting will be updated.

3 - 1

Page 37
Image 37
Honeywell 2700 manual Programming the Bioptic Scanner Interface, Introduction, Menu Bar Code Security Settings