Honeywell 2700 manual Block Check Character, NCR Prefix, NCR Suffix, NCR NOF Not-on-File Error

Block Check Character

When this selection is set to Transmit, the NCR Block Check Character (BCC) is expected with incoming messages and

transmitted with outgoing messages. Default = Transmit.

* Transmit

Don’t Transmit

NCR Prefix

This selection allows you to program an NCR-specific prefix. Refer to the ASCII Conversion Chart (Code Page 1252) on page A-3to find the hex equivalent for the characters you want for the NCR prefix (typically, 02 for STX). Scan the bar code below, then set the hex number (from 0-FF) by scanning digits from the Programming Chart, then scanning Save.

Default = 0.

NCR Prefix

NCR Suffix

This selection allows you to program an NCR-specific suffix. Refer to the ASCII Conversion Chart (Code Page 1252) on page A-3to find the hex equivalent for the characters you want for the NCR suffix (typically, 03 for ETX). Scan the bar code below, then set the hex number (from 0-FF) by scanning digits from the Programming Chart, then scanning Save.

Default = 0.

NCR Suffix

NCR NOF (Not-on-File) Error

A scanner receives an NOF (Not on File) command from the POS whenever it cannot cross-reference the bar code to a price parameter. When set to On, the error tone sounds for an NOF, and disables the scanner while the cashier looks up the price manually. (The tone is set via Beeper Pitch – Error, page 4-11and number of beeps are set via NCR NOF (Not-

on-File) Number of Beeps, page 3-35). When set to Off, a good read beep sound is emitted for an NOF. Default = Off.

On

3 - 34