Honeywell 2700 manual Step, Group 2 bld Weight Unit Ranges

Step 1.		Press the Zero key on the remote display several times until Grp 2 Step1 is displayed.
						21
					Grp 2
					Step 1
Step 2.		Either display will initially display x = NO. Press the Tare					key to change this to YES:
		21 YES
Step 3. Press the Zero				key to select YES.
Step 4. Press the Tare				key until bLd 2 displays:
		bLd 2
Step 5.		This is the weight range selection against which the load cell is measured. Using the table below, press the Tare
			key to rotate around the bLd 2 selections. Press the Zero					key to select the bld range desired.
		Group 2 Step 1 bld			Weight Unit Ranges
		Bld	0		15 kg Single Range
		Bld	1		15 Kg Dual Range*
		Bld	2		30 lb Single Range*
		Bld	3		30 lb Dual Range
	* Common Ranges used as default for most country settings
Step 6. Press the Zero				key to display the Cal prompt.
Step 7. Press the Tare				key to select YES:
		CAL YES
Step 8. Press the Zero				key to start the scale calibration.
Step 9.		The display shows - - - - - -:

------

This indicates that the scale is ready to take a zero reading. Check the platter to ensure that it is seated properly and nothing is touching or interfering with its freedom to move.

6 - 6