Honeywell 2700 manual NCR Modifiers, RS232 Defaults, NCR Modes, NCR Scanner Only Mode

RS232 Defaults

If you want the custom RS232 default settings restored to your scanner, scan the RS232 Defaults bar code below. This resets the scanner to the custom default settings (see Setting Custom Defaults on page 3-1). If there are no custom defaults, it will reset the scanner to the factory default settings. Any settings that have not been specified through the cus- tom defaults will be restored to the factory default settings.

RS232 Defaults

NCR Modifiers

NCR ACK/NAK

This is an NCR communication protocol for ACK/NAK processing. Default = NCR ACK/NAK Off.

* NCR ACK/NAK Off

NCR ACK/NAK On

NCR Modes

Scan one of the following bar codes to set the message mode for an attached NCR device.

NCR Scanner Only Mode

Scan the NCR Scanner Only Mode On bar code to select the NCR scanner-only message format. (For more informa-

tion, refer to the NCR Scanner/Scale Programmer’s Guide.) Default = NCR Scanner Only Mode Off.

* NCR Scanner Only Mode Off

NCR Scanner Only Mode On

3 - 32