Honeywell 2700 HSTDEN0 HSTDEN1, Hstdch##, Seqblk, Seqdft, Seqdly#####, SEQBEP1, SEQBEP0, SEQTTS1

Selection	Setting	Serial Command	Page
		# Indicates a numeric
	* Indicates default
		entry
Character Deactivation Mode	*Off	HSTDEN0	4-16
	On	HSTDEN1	4-16
	Deactivation Character	HSTDCH##	4-16
Output Sequence Editor	Enter Sequence	SEQBLK	4-18
	Default Sequence	SEQDFT	4-18
Sequence Timeout	(Range 1 - 65535) *5000 ms	SEQDLY#####	4-19
Sequence Match Beeper	*On	SEQBEP1	4-19
	Off	SEQBEP0	4-19
Partial Sequence	Transmit Partial Sequence	SEQTTS1	4-19
	*Discard Partial Sequence	SEQTTS0	4-19
Require Output Sequence	Required	SEQ_EN2	4-20
	On/Not Required	SEQ_EN1	4-20
	*Off	SEQ_EN0	4-20
No Read	On	SHWNRD1	4-20
	*Off	SHWNRD0	4-20
Programming the Auxiliary Scanner	Interface
Scanner to Bioptic Communication
Scanner-Bioptic Packet Mode	*Packet Mode Off	232PKT0	5-1
	Packet Mode On	232PKT2	5-1
ACK/NAK	ACK/NAK On	232ACK1	5-1
	*ACK/NAK Off	232ACK0	5-1
Communication Timeout	Range 0 - 65535ms *2000	232DLK#####	5-1
Honeywell Scanner Aux Port Configuration	Honeywell Aux Scanner	AUXDFT	5-2
Datalogic Magellan Aux Port Configuration	Datalogic Magellan Aux Scanner	AUXMAG	5-2
NCR Bioptic Aux Port Configuration	NCR Aux Scanner	AUXNCR	5-2
Wincor Nixdorf Beetle Aux Port	Wincor Nixdorf Beetle Aux Scanner	AUXBTL	5-2
Configuration
Good Read Beep - Aux Scanner	*Good Read Beep - Bioptic and Aux Scanner	AUXBEP1	5-3
	Good Read Beep - Aux Scanner	AUXBEP0	5-3
Aux Scanner D/E Commands	Use D/E Commands	AUXDEC1	5-3
	*Do Not Use D/E Commands	AUXDEC0	5-3
Reread Delay Override	*Reread Delay from Aux Scanner	AUXDSS1	5-3
	Reread Delay from Bioptic	AUXDSS0	5-3
Scale
RS232	Baud Rate/Parity	232BAD5;2332WR	6-1
		D2
	Single Cable	SCLSGL1	6-1
	External Scale Display	SCLDSP1	6-1
	NCR Protocol English (lbs) - Single Cable	PAP956	6-1
	NCR Protocol Metric (kg) - Single Cable	PAP955	6-1
	*POS - Don’t Beep on Send Weight	NCRBWS0	6-2
	POS - Beep on Send Weight	NCRBWS1	6-2

13 - 11